composants:attiny85

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision		 Previous revision
composants:attiny85 [2020/02/20 21:45] – [Wiring] mhcomposants:attiny85 [2025/06/02 21:23] (current) – external edit 127.0.0.1
Line 11: Line 11:
 Also, the ATtiny85 runs by default at 1MHz so if you want it to run at 8MHz you need to burn the bootloader into it after having selected the appropriate frequency. Also, the ATtiny85 runs by default at 1MHz so if you want it to run at 8MHz you need to burn the bootloader into it after having selected the appropriate frequency.
  
-//**Note :** Arduino in the past did not support ATtiny by default and additional libs had to be provided. Sooner or later this might not be the case anymore.//+<WRAP info round 95> 
 + 
 +**Note :** Arduino in the past did not support ATtiny by default and additional libs had to be provided.  
 + 
 +Sooner or later this might not be the case anymore. 
 +</WRAP>
  
 The Arduino UNO should be flashed with the ISP program : File > Examples > ArduinoISP The Arduino UNO should be flashed with the ISP program : File > Examples > ArduinoISP
Line 33: Line 38:
  
   *[[https://create.arduino.cc/projecthub/arjun/programming-attiny85-with-arduino-uno-afb829|Basic programming tutorial]]   *[[https://create.arduino.cc/projecthub/arjun/programming-attiny85-with-arduino-uno-afb829|Basic programming tutorial]]
 +
 +  *[[https://www.re-innovation.co.uk/docs/sleep-modes-on-attiny85/|Sleep Mode tutorial]]
  • composants/attiny85.1582231523.txt.gz
  • Last modified: 2025/06/02 21:17
  • (external edit)