Differences
This shows you the differences between two versions of the page.
| 3d-print:print-tips [2026/01/24 08:46] – created mh | 3d-print:print-tips [2026/01/24 08:47] (current) – [Cold casting 3D prints with metal powder] mh | ||
|---|---|---|---|
| Line 4: | Line 4: | ||
| Found on this [[https:// | Found on this [[https:// | ||
| - | 3d print a part | + | * 3d print a part |
| - | Make a mold container (out of a plastic cup) and hot glue it to a support surface | + | |
| - | Hot glue the part inside the container | + | |
| - | Mix the two part resin in proper proportions | + | |
| - | Pour it evenly and gently in the container to make the cast | + | |
| - | Spray the mold with mold release | + | |
| - | Mix iron powder with proper resin (ventilate, protect eyes and lungs) and add catalyst (dangerous) | + | |
| - | Pour metal/resin mix gently and evenly in mold | + | |
| - | When set, unmold | + | |
| - | Tarnish and apply quick-rust | + | |
| - | Tarnish again so the rust is only in the recessed details | + | |